Gtco Summagrid VII - Quick Start Guide Uživatelský manuál Strana 1

Procházejte online nebo si stáhněte Uživatelský manuál pro Počítačový hardware Gtco Summagrid VII - Quick Start Guide. GTCO Summagrid VII - Quick Start Guide User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 3
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Contents
Verify that your Summagrid VII package includes the following:
Summagrid VII digitizing tablet
Transducer (corded or cordless pen,
4-button or 16-button cursor)
Computer interface with 9-pin
connector for RS-232 serial
connection
USB cable
Power supply
CD with drivers and diagnostics
(varies with configuration)
User’s guide
Registration card
Optional Equipment
Mounting brackets
Accessory tray
Plan holder
Two feet
Manual lift/manual tilt pedestal
NOTE: Some digitizing applications (typically, non-Windows CAD applications where the
tablet is used solely as a digitizer with no mouse functions) may not require the use of the
TabletWorks software. To configure Summagrid VII for use with a third-party application,
please refer to the installation instructions in the Summagrid VII User’s Guide, or the
Summagrid VII Help file.
NOTE: If your digitizing tablet came with a TabletWorks CD, install the software FIRST, and
then setup the hardware connections for USB or serial, following the instructions below.
Software Configuration
Software drivers provide the communication bridge between your software application and
Summagrid VII. The GTCO CalComp by Turning Technologies-supplied TabletWorks CD
supports reduced functionality Wintab and TabCon-compatible applications. If you are not
sure about your application’s driver requirements, contact your application vendor.
Zobrazit stránku 0
1 2 3

Shrnutí obsahu

Strany 1 - Software Configuration

Contents Verify that your Summagrid VII package includes the following:  Summagrid VII digitizing tablet  Transducer (corded or cordless pen,

Strany 2 - RS-232 Serial Connection

Installing the Driver Insert the CD into the CD-ROM drive on your computer and follow the onscreen prompts to complete the driver installation. I

Strany 3

3. Plug the power supply into an AC outlet. Connect the power supply to the appropriate jack on the Connector Panel. Turn the power switch on.

Komentáře k této Příručce

Žádné komentáře