Gtco Summagrid IV - Users Guide Part 1 Uživatelský manuál stáhnout pdf (Strana 21)

Summagrid IV 21

4.2.2 Using DGMG.COM

First make sure that DGMG.COM is in the current directory. Then, at the DOS

prompt type the following:

DGMG [Com port] [Transducer] [Mode] where [com port], [transducer] and [mode]

are replaced with the options listed below. If the user only types DGMG, the tablet

defaults to the options marked with an asterisk (*).

NOTE: Use of the /AS option makes DGMG.COM a non-ADI specification driver.

Although the /AS option allows the screen and tablet to have the same aspect ratio,

approximately two inches on the right-hand side of the screen cannot be accessed

when in this mode. As a result, certain dialog box buttons (Cancel and OK) cannot

be accessed by the tablet. However, the user may activate these commands by

using the ESC and ENTER keys on the keyboard.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 42 43

Žádné komentáře

Gtco Summagrid IV - Users Guide Part 1 Uživatelský manuál Strana 21